GE 28320ee2 Quick Setup Guide

If trouble is experienced with this equipment, for repair or warranty information, please 

contact customer service at 1-800-448-0329.

Make sure your package includes the items shown here.

•  Avoid sources of noise and heat, such as motors, fluorescent lighting, microwave ovens, 

heating appliances and direct sunlight.

•  Avoid areas of excessive dust, moisture and low temperature.
•  Avoid other cordless telephones.
•  Never install telephone wiring during a lightning storm.

Your cordless phone uses a digital security system to protect against false ringing, 

unauthorized access, and charges to your phone line.

To use this phone, you need an RJ11C type modular telephone jack, which might 

look like the one pictured here, installed in your home. If you don’t have a modular 

jack, call your local phone company to find out how to get one installed.

You need to place the base within 6 feet of the AC power outlet, telephone jack, and 

ethernet port. Make sure it is at least 3 feet away from other electrical and metal 

appliances to avoid interference issues.

Your phone works by sending radio signals between the handset and base. The strength 

of the signal depends on where you locate the base. Putting it as high as possible and 

separated as much as possible from other radio devices and metal objects ensures the 

best signal.

The range between the base and handset will vary greatly depending on the location of the 

base. When there is no clear line of sight between the base and handset the range will be 

reduced.

The   symbol on your handset screen indicates when you are in range. When you are out 

of range, it flashes.
Your unit is provided with three power adaptors; 2 for handset charger cradles and 1 base 

power. The connectors are different sizes, only the larger power adaptor is for the base unit.

1.  Locate batteries and battery door which are packaged together inside a plastic bag 

and are separate from the handsets.

2.  Locate the battery compartment on the back of 

the handsets.

3.  Insert the batteries.
4.  Close the battery compartment by pushing the 

door up until it snaps into place.

5.   Plug the AC power adaptor of the charge cradle 

into an electrical outlet.

6.   Place the handsets in the charge cradles. The blue CHARGE indicator turns on, verifying 

the batteries are charging.

When batteries are fully charged the handset displays an icon of a full battery. To keep your 

batteries in the best condition, leave the handset off the charge cradle for a few hours at a 

time (after the initial 16 hour charge).
Please note however, that new NiMH batteries do not reach full capacity until they have 

been in normal use for several days.

The handset displays a flashing icon of an “empty” battery and sounds a warning beep. 

Recharge your handset right away. When charging the battery, level bars are animated.

The blue charging light on the handset charge cradle stays on while the handset is on the 

cradle, even when the batteries are fully charged.

The base needs a direct access connection to the internet, and the IP address of the base 

must be provided by a DHCP server.

1.  Using the ETHERNET cable (RJ45 ) provided with your phone, connect the cable to your 

broadband modem or router with cable access.

2.  Connect the other end of the cable to the base ETHERNET port.

Model 28320  QSG

00023523 (Rev. 1 DOM E)

07-46

Printed in China

101 West 103rd St., 

Indianapolis, IN 46290-1102

© 2007 Thomson Inc. 

Trademark(s) ® Registered 

Marca(s) Registrada(s)