Glastender bb108 User Guide

Glastender, Inc.  •  5400 North Michigan Road •  Saginaw, MI  •  48604-9780  

800.748.0423  •  989.752.4275  •  Fax 800.838.0888 / 989.752.4444  •  www.glastender.com

3

COOLER DOOR

COOLER CABINET

1" BASE

BEAD SEALANT

FLOOR

MAGNETIC GASKET

Side View of Cabinet

Cleaning is essential to sustaining the integrity of your equipment and preventing corrosion.
ESTIMATED CLEANING TIME: 5 to 10 minutes per unit daily, 45 minutes quarterly
FREQUENCY: Daily cleaning of exterior & door gaskets. Quarterly cleaning of interior, including shelves.
PROCEDURE:

1.  A non-chlorine based cleaner or mild detergent and warm water applied with a soft cloth or sponge to all 

contact surfaces.

2.  Immediately rinse off cleaning agent(s), using clean warm water, clean soft cloth or sponge.

3.  Dry with a soft clean cloth, removing standing water as soon as possible.
NOTES:
1.  Never use hydrochloric acid, wire brushes, steel wool, scrapers, or chlorine based cleaners on stainless steel 

surfaces, since they will break down the passivity layer and allow corrosion to occur.

2.  On stainless steel surfaces, you may use a soft bristle brush or Scotch-Brite® pad for more stubborn stains. 

Always scrub with the direction of the grain. Follow with a thorough cleaning as described above.

3.  Deposits from food preparation must be properly removed. Even hard water deposits will rust stainless steel, 

if not removed.

4.  Repeated cleaning may dry up black-vinyl-clad steel (exterior) surfaces of the cooler.  Armor All® or similar 

product can bring back the shine. Apply the product to a cloth and then rub into the surface, rather than spray-

ing it directly onto the black-vinyl-clad surface.

5.  The cooler door gaskets are most often overlooked when cleaning. Failure to clean them regularly will lead to 

premature failure, since alcohol and moisture build-up breaks down the gasket material.

To comply with NSF & health codes,  the cooler base must be sealed to the floor using NSF listed sealant.  Place 

a bead of sealant along outer edges of the base and remove excess with disposable towel.  The floor sealing 

procedure does not apply to models that include legs or casters.