Bosch she43m06uc Information Guide
2
1
3 TBS MAX
2 TBS (25 ML)
1 TBS (15 ML)
•
Use fresh powdered detergent
for best results
•
1 tablespoon will clean most loads
•
3 tablespoons Max, do not overfi ll
•
When using detergent tabs, lay
them fl at to avoid contact with the
cover
cover
GETTING STARTED
WITH YOUR NEW DISHWASHER
STEP 1- ADDING RINSE AGENT
•
To add Rinse Agent
pour on the arrow
•
Turn arrow to
adjust the amount
of rinse agent
dispensed
of rinse agent
dispensed
•
Add Rinse Agent when the light
on the control panel illuminates
or (Model Dependent)
Rinse Agent Level indicator on
the dispenser changes to a
light silver color
•
Add
Detergent
•
To close
•
If you should
need to open
the cover
the cover
STEP 2 - ADDING DETERGENT
STEP 3 - TO START THE DISHWASHER
Exposed
Front
Controls
Hidden Top
Controls
ALWAYS READ YOUR USE AND CARE MANUAL FOR DETAILED INSTRUCTIONS AND
IMPORTANT SAFETY NOTICES.
Cancel Drain
To Contact Customer Service
With the dishwasher door open, locate the label on the right side
of the door. There you will fi nd the:
• Model
of the door. There you will fi nd the:
• Model
Number
• Serial
Number
(FD#########)
• Toll Free Customer Service Phone Number
Run Time
To save energy, this dishwasher has a "Smart Control" that au-
tomatically adjusts the cycle based on soil loads and incoming
water temperature. The "Smart Control" makes decisions that can
cause the cycle time and water usage to adjust at discrete times,
and suddenly change in midcycle. The cycle times listed in the
Use and Care manual are based on normal soil loads and 120°F
incoming water and will vary based on your actual conditions.
tomatically adjusts the cycle based on soil loads and incoming
water temperature. The "Smart Control" makes decisions that can
cause the cycle time and water usage to adjust at discrete times,
and suddenly change in midcycle. The cycle times listed in the
Use and Care manual are based on normal soil loads and 120°F
incoming water and will vary based on your actual conditions.
When is the Cycle Complete
Depending on model you can tell when your unit has completed
the cycle in one of the following ways. Please refer to your Use
and Care manual for complete details
• Countdown
the cycle in one of the following ways. Please refer to your Use
and Care manual for complete details
• Countdown
Display
at
"0"
• Clean
Light
illuminates
• Cycle completion signal sounds (tone adjustable)
• Cycle indicator light that shines on fl oor goes out
• Cycle indicator light that shines on fl oor goes out
Canceling a Cycle
Be careful of splash-out.
To cancel a cycle in process, press and hold the two buttons
labeled "Cancel Drain" for 3 seconds. Re-start the dishwasher
as normal
To cancel a cycle in process, press and hold the two buttons
labeled "Cancel Drain" for 3 seconds. Re-start the dishwasher
as normal
FREQUENTLY ASKED
QUESTIONS
For Proper Drying Always use Rinse Agent
even if your detergent containes Rinse Agent
9000121317 Rev. B • 02/06
Arrow
Turn
Decrease
for
Streaks on
glasses
Increase
for
Spots on
glasses
1
2
•
Push the blue button in
(NOT DOWN)
•
Lift tab to
open
Slide cover fully left
Push rear of cover down
fi rmly until you hear the
fi rmly until you hear the
CLICK
1) Close the door
2) Turn on
2) Turn on
3) Select a cycle
3) Select a cycle
1) Open the door
4) The unit will
then
then
start
4) Close the
door to start
Rinse Agent
Level