Partner Tech pt-5700 User Manual

These items can be used to install a password. A Supervisor password takes precedence over a User password, and the 
Supervisor can limit the activities of a User. To install a password, follow these steps:

1. Highlight the item Set Supervisor/User Password on the main menu and press <Enter>.
2. The password dialog box appears.

3. If you are installing a new password, type in the password. You cannot use more than eight characters 

or numbers. The Set Supervisor/User Password item differentiates between upper and lower case 

characters. Press <Enter> after you have typed in the password. If you are deleting a password that is 

already installed press <Enter> when the password dialog box appears. You see a message that 

indicates that the password has been disabled.

4. Press any key. You are prompted to confirm the password. 

5. Type the password again and press <Enter>, or press <Enter> if you are deleting a password that is 

already installed.

Write the passwords down and keep them in a safe place.

Highlight this item and press <Enter> to save the changes that you have made in the Setup Utility and exit the Setup 
Utility. When the Save and Exit dialog box appears, press <Y> to save and exit, or press <N> to return to the main 
menu.

Highlight this item and press <Enter> to discard any changes that you have made in the Setup Utility and exit the Setup 
Utility. When the Exit Without Saving dialog box appears, press <Y> to discard changes and exit, or press <N> to 
return to the main menu.

IMPORTANT

If you do not save changes when you exit BIOS, changes to the passwords will be saved 
anyway.

NOTE