Alcatel-Lucent 6850-48 Supplementary Manual
Working With Configuration Files
Quick Steps for Applying Configuration Files
OmniSwitch AOS Release 6 Switch Management Guide
September 2009
page 7-5
request, enter the
command. The display is similar to the one shown here.
-> show configuration status
File configuration </flash/working/bncom_cfg.txt>: scheduled at 07/04/02 09:00
For more information about this display see “Configuration File Manager Commands” in the OmniSwitch
CLI Reference Guide.
CLI Reference Guide.
Setting an Application Session for a Specified Time Period
You can set a future timed session to apply a configuration file after a specified period of time has elapsed.
In the following example, the amzncom_cfg.txt will be applied after 6 hours and 15 minutes have
elapsed.
In the following example, the amzncom_cfg.txt will be applied after 6 hours and 15 minutes have
elapsed.
1 Verify that there are no current timer sessions pending on the switch.
-> show configuration status
File configuration: none scheduled
2 Apply the file by executing the
time frame specified.
-> configuration apply amzncom_cfg.txt in 6:15
request, enter the
command. The display is similar to the one shown here.
-> show configuration status
File configuration </flash/working/amzncom_cfg.txt>: scheduled at 03/07/02 05:02
The “scheduled at” date and time show when the file will be applied. This value is 6 hours and 15 minutes
from the date and time the command was issued.
from the date and time the command was issued.
For more information about this display see “Configuration File Manager Commands” in the OmniSwitch
CLI Reference Guide.
CLI Reference Guide.