Alcatel-Lucent 6850-48 Network Guide

Switch Logging Commands Overview

Using Switch Logging

page 46-10

OmniSwitch AOS Release 6 Network Configuration Guide

To disable all configured output IP addresses from receiving switch logging output, enter the following 
command:

-> no swlog output socket

No confirmation message will appear on the screen.

To disable a specific configured output IP address from receiving switch logging output, use the same 
command as above but specify an IPv4 or IPv6 address. For example:

-> no swlog output socket 174.16.5.1

You can display the current status of switch logging on your console screen by using the 

command. The following information is displayed:

• The enable/disable status of switch logging.

• A list of current output devices configured for switch logging.

• The switch logging severity level for each application that is not set to the “info” (6) setting.

The following is a sample display:

-> show swlog

Switch Logging is:

- INITIALIZED

- RUNNING

Log Device(s)

----------------

flash

console

Only Applications not at the level ‘info’ (6) are shown

Application ID

Level

----------------------------

CHASSIS (64)

debug3 (9)

->

For this example, switch logging is enabled. Switch logging information is being sent to the switch’s flash 
memory and to the console. Additionally, the severity level for the chassis application ID has been set to 
the “debug3” (or “9”) severity level.