Alcatel-Lucent 6850-48 Network Guide

Configuring VLAN Rule Definitions

Defining VLAN Rules

page 8-14

OmniSwitch AOS Release 6 Network Configuration Guide

To define a MAC-port binding rule, enter vlan followed by an existing VLAN ID then binding mac-port 
followed by a valid MAC address and a slot/port designation. For example, the following command 
defines a MAC-port binding rule for VLAN 1500:

-> vlan 1500 binding mac-port 00:02:9a:3e:f1:06 6/10

In this example, frames received on mobile port 6/10 must contain a source MAC address of 
00:02:9a:3e:f1:06 to qualify for dynamic assignment to VLAN 1500.

Use the no form of the 

 command to remove a MAC-port binding rule. Note that it 

is only necessary to enter the rule’s MAC address parameter value to identify which rule to remove.

-> vlan 1500 no binding mac-port 00:02:9a:3e:f1:06

Note that this binding rule type is also supported on AVLANs. See 

 for more information. 

To define a port-protocol binding rule, enter vlan followed by an existing VLAN ID then 
binding port-protocol followed by a valid MAC address, a slot/port designation and a protocol type. For 
example, the following commands define a port-protocol binding rule for VLAN 1503 and VLAN 1504:

-> vlan 1503 binding port-protocol 3/1 ip-snap

-> vlan 1504 binding port-protocol 4/1 dsapssap F0/F0

The first example command specifies that frames received on mobile port 3/1 must contain an IP SNAP 
protocol type to qualify for dynamic assignment to VLAN 1503. The second command specifies that 
frames received on mobile port 4/1 must contain a DSAP/SSAP protocol value of F0/F0 to qualify for 
dynamic assignment to VLAN 1504.

The following table lists command keywords for specifying a protocol type:

Note that specifying a SNAP protocol type restricts classification of mobile port traffic to the ethertype 
value found in the IEEE 802.2 SNAP LLC frame header.

Use the no form of the 

 command to remove a port-protocol binding rule. 

-> vlan 255 no binding port-protocol 8/12 ethertype 0600