Alcatel-Lucent 6850-48 Network Guide

Page of 1162
Configuring MPLS
Quick Steps for Configuring MPLS
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
page 10-7
Configure keepalive timeout interval for targeted LDP sessions using the 
 command. For example:
-> configure router ldp targeted-session keepalive 40 2
Quick Steps for Configuring LDP Graceful Restart 
The graceful restart mechanism is always enabled for the switch. The following steps provide a quick tuto-
rial for configuring the graceful restart helper status and timers:
Enable the Graceful Restart Helper for the switch using the 
 command. For example:
-> configure router ldp graceful-restart-helper 
Configure the reconnect time advertised to neighboring LDP routers using th
-> configure router ldp reconnect-time 300
Configure the MPLS forwarding state hold time using th
 command. For example:
-> configure router ldp fwd-state-holding-time 300
Configure the amount of time stale label-FEC bindings are retained using th
 command. For example:
-> configure router ldp maximum-recovery-time 300
Configure the amount of time to wait for a neighbor to re-establish an LDP session using the 
 command. For example:
-> configure router ldp neighbor-liveness-time 300
Note. Optional. Verify LDP parameter settings using the 
 command. For 
example:
->show router ldp parameters
LDP Parameters (LSR ID 10.10.0.7)
Graceful Restart Parameters
Fwd State Hold Time (sec):  120, 
Reconnect Time (sec):
120,
Nbor Liveness Time (sec):   120, 
Max Recovery Time (sec): 120
Interface Parameters
Keepalive Timeout (sec): 
30,
Keepalive Factor:
3,
Hold Time (sec): 
15, 
Hello Factor: 
3, 
Propagate Policy: 
system,
Transport Address:
system, 
Deaggregate FECs: 
False, 
Route Preference: 
9, 
Label Distribution: 
downstreamUnsolicited, Label Retention: 
liberal,
Control Mode:               ordered,               Loop Detection: 
none 
Targeted Session Parameters
Keepalive Timeout (sec):    40,                    Keepalive Factor: 
4, 
Hold Time (sec):            45,                    Hello Factor: 
3, 
Passive Mode:               False,                 Targeted Sessions:  Enabled