Alcatel-Lucent 6850-48 Network Guide
Configuring STP Port Parameters
Configuring Spanning Tree Parameters
page 13-28
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
The following sections provide information and procedures for using implicit Spanning Tree port configu-
ration commands and also includes explicit command examples.
ration commands and also includes explicit command examples.
Note. When a snapshot is taken of the switch configuration, the explicit form of all Spanning Tree
commands is captured. For example, if the bridge protocol for the flat mode instance was changed from
STP to MSTP, then bridge cist protocol mstp is the command syntax captured to reflect this in the snap-
shot file. In addition, explicit commands are captured for both flat and 1x1 mode configurations.
commands is captured. For example, if the bridge protocol for the flat mode instance was changed from
STP to MSTP, then bridge cist protocol mstp is the command syntax captured to reflect this in the snap-
shot file. In addition, explicit commands are captured for both flat and 1x1 mode configurations.
Explicit
Configures the connection type for a port or an aggregate
of ports for the flat mode Common and Internal Span-
ning Tree (CIST).
of ports for the flat mode Common and Internal Span-
ning Tree (CIST).
Explicit
Configures the connection type for a port or an aggregate
of ports for a 1x1 mode VLAN instance.
of ports for a 1x1 mode VLAN instance.
Explicit
Configures a port or an aggregate of ports for the flat
mode Common and Internal Spanning Tree (CIST) as an
edge port, automatically.
mode Common and Internal Spanning Tree (CIST) as an
edge port, automatically.
Explicit
Configures a port or an aggregate of ports for the 1x1
mode VLAN instance as an edge port, automatically.
mode VLAN instance as an edge port, automatically.
Explicit
Configures the restricted role status for a port or an
aggregate of ports for the flat mode Common and Inter-
nal Spanning Tree (CIST) as a restricted role port.
aggregate of ports for the flat mode Common and Inter-
nal Spanning Tree (CIST) as a restricted role port.
Explicit
Configures a port or an aggregate of ports for the 1x1
mode VLAN instance as a restricted role port.
mode VLAN instance as a restricted role port.
Explicit
Configures a port or an aggregate of ports for the flat
mode Common and Internal Spanning Tree (CIST) to
support the restricted TCN capability.
mode Common and Internal Spanning Tree (CIST) to
support the restricted TCN capability.
Explicit
Configures a port or an aggregate of ports for the 1x1
mode VLAN instance to support the restricted TCN
capability.
mode VLAN instance to support the restricted TCN
capability.
Explicit
Limits the transmission of BPDU through a given port
for the flat mode Common and Internal Spanning Tree
(CIST).
for the flat mode Common and Internal Spanning Tree
(CIST).
Explicit
Limits the transmission of BPDU through a given port
for the 1x1 mode VLAN instance.
for the 1x1 mode VLAN instance.
Explicit
Configures the type of BPDU to be used on a port when
PVST+ mode is enabled.
PVST+ mode is enabled.
Commands
Type
Used for ...