Alcatel-Lucent 6850-48 Network Guide

Configuring Ethernet OAM

Configuring Ethernet OAM

OmniSwitch AOS Release 6 Network Configuration Guide

page 15-11

The Fault Alarm time is the period of time during which one or more defects should be detected before the 
Fault Alarm is issued. The 

 command can be used to configure the timeout value 

for the Fault Notification Generation Alarm Time.

To configure the Fault Alarm time, enter the ethoam fault-alarm-time command, followed by the 
number of seconds.

For example, to configure the Fault Alarm time value as 10 seconds, you would enter:

-> ethoam fault-alarm-time 10 end-point 100 domain esd.alcatel-lucent.com asso-

ciation alcatel_sales

The Fault Reset time is the time interval in which Fault Alarm is re-enabled to process the faults. The 

 command can be used to configure the timeout value for the Fault Notification 

Generation Reset Time.

To configure the Fault Reset time, enter the ethoam fault-reset-time command, followed by the number 
of seconds.

For example, to configure the Fault Reset time interval as 5 seconds, you would enter:

-> ethoam fault-reset-time 5 end-point 100 domain esd.alcatel-lucent.com associ-

ation alcatel_sales