Alcatel-Lucent 6850-48 Network Guide
RIP Specifications
Configuring RIP
page 28-2
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
RIP Specifications
RIP Defaults
The following table lists the defaults for RIP configuration through the ip rip command.
RFCs Supported
RFC 1058–RIP v1
RFC 2453–RIP v2
RFC 1722–RIP v2 Protocol Applicability Statement
RFC 1724–RIP v2 MIB Extension
RFC 2453–RIP v2
RFC 1722–RIP v2 Protocol Applicability Statement
RFC 1724–RIP v2 MIB Extension
Platforms Supported
OmniSwitch 6400, 6800, 6850, 6855, and 9000
Maximum Number of RIP Peers
(Note: This max value was not included in
Specs table prior to 6.3.3.)
(Note: This max value was not included in
Specs table prior to 6.3.3.)
10 (OmniSwitch 6400)
Maximum Number of RIP Interfaces
(Note: This max value was not included in
Specs table prior to 6.3.3.)
(Note: This max value was not included in
Specs table prior to 6.3.3.)
10 (OmniSwitch 6400)
Maximum Number of RIP Routes
2048
(Note: The “2048” value was previously documented,
however, the 6.3.3 Porting SFS specifies 1K for OS6850
and “NA” for OS6400. What values should be used?)
(Note: The “2048” value was previously documented,
however, the 6.3.3 Porting SFS specifies 1K for OS6850
and “NA” for OS6400. What values should be used?)
Description
Command
Default
RIP Status
disable
RIP Forced Hold-Down Interval
0
RIP Update Interval
30 seconds
RIP Invalid Timer
180 seconds
RIP Garbage Timer
120 seconds
RIP Hold-Down Timer
0
RIP Interface Metric
1
RIP Interface Send Version
v2
RIP Interface Receive Version
both
RIP Host Route
enable
RIP Route Tag
0