Alcatel-Lucent 6850-48 Network Guide

Setting Ethernet Combo Port Parameters

Configuring Ethernet Ports

page 1-28

OmniSwitch AOS Release 6 Network Configuration Guide

To disable flow control, use the disable parameter with the interfaces hybrid pause command. 
For example:

-> interfaces 1/23 hybrid fiber pause disable

If the interfaces hybrid pause command is used to configure E2E flow control on a 48-port standalone 
OmniSwitch 6400 or OmniSwitch 6850, then configuring a flow control VLAN is also required. For 
example, the following command configures VLAN 700 as a flow control VLAN:

-> interfaces e2e-flow-vlan 700

Note that the VLAN specified with the above command must already exist in the switch configuration. In 
addition, flow control VLANs are not configurable using standard VLAN management commands.

There is only one flow control VLAN configured per switch. To remove this type of VLAN, use the no 
form of the interfaces e2e-flow-vlan command. Note that specifying a VLAN ID is not necessary. For 
example, the following command removes the flow control VLAN from the switch configuration:

-> interfaced no e2e-flow-vlan

For more information about the 

 command syntax, 

see the “Ethernet Port Commands” chapter in the OmniSwitch CLI Reference Guide.