Alcatel-Lucent 6850-48 Reference Guide
MPLS LDP Commands
page 24-58
OmniSwitch CLI Reference Guide
September 2009
Local Cfg Seq No: 3, Remote Cfg Seq No: 3
->show router ldp discovery peer 10.11.0.6 state down
Interface Name Local Addr Peer Addr AdjType State
--------------------------------+---------------+---------------+-------+------
No Matching Entries Found
->show router ldp discovery peer 10.11.0.6 state established
Interface Name Local Addr Peer Addr AdjType State
--------------------------------+---------------+---------------+-------+------
vlan-30 10.11.0.6 10.10.0.7 Link Estab
No. of Hello Adjacencies: 1
->show router ldp discovery peer 10.11.0.6 state trying
Interface Name Local Addr Peer Addr AdjType State
--------------------------------+---------------+---------------+-------+------
No Matching Entries Found
output definitions
Interface Name
The name of the local LDP IP interface.
Local Addr
The IP address of the local router.
Peer Addr
The IP address of the LDP peer.
AdjType
The type of adjacency between the local LDP interface and the LDP
peer (Link–peers directly connected establish linked sessions or Targ–
peers not directly connected establish targeted sessions).
peer (Link–peers directly connected establish linked sessions or Targ–
peers not directly connected establish targeted sessions).
State
The status of the LDP hello adjacency (Estab, Trying, or Down).
No. of Hello Adjacencies
The number of LDP hello adjacencies discovered.
Up Time
The amount of time the adjacency has been established.
Hold Time Remaining
The amount of time left before the peer for this adjacency is declared
down.
down.
Hello Mesg Recv
The number of Hello messages received from this adjacency.
Hello Mesg Sent
The number of Hello messages sent for this adjacency.
Local IP Address
The IP address of the local IP interface for this adjacency.
Remote IP Address
The IP address of the peer IP interface for this adjacency.
Local Hello Timeout
The Hello Timeout value configured for the local router.
Remote Hello Timeout
The Hello Timeout value configured for the peer.
Local Cfg Seq No
The configuration sequence number that was in the Hello received
when this adjacency started up. This configuration sequence number
changes when there is a change of configuration.
when this adjacency started up. This configuration sequence number
changes when there is a change of configuration.
Remote Cfg Seq No
The configuration sequence number that was in the Hello received
when this adjacency started up. This configuration sequence number
changes when there is a change of configuration.
when this adjacency started up. This configuration sequence number
changes when there is a change of configuration.