Alcatel-Lucent 6850-48 Reference Guide
Virtual Private LAN Service (VPLS) Commands
page 26-102
OmniSwitch CLI Reference Guide
September 2009
show service sdp-using
Displays the Service Distribution Point (SDP) usage for the local router or for a far-end router IP address.
show service sdp-using [sdp-id[:vc-id] | far-end ip-address]
Syntax Definitions
sdp-id
An existing SDP ID number.
vc-id
A VC ID number used to validate the VC ID portion of each mesh SDP
binding defined for the service.
binding defined for the service.
ip-address
The system IP address for the far-end router. This is the user-configured
Loopback0 address if the far-end router is an OmniSwitch.
Loopback0 address if the far-end router is an OmniSwitch.
Defaults
By default, a list of all associated SDPs configured for the switch is displayed.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
• Use the sdp-id parameter to display information for a specific SDP.
• Use the far-end ip-addr parameter to display information about an SDP with a specific far-end
address.
Examples
-> show service sdp-using
SDP Using
SvcId SdpId Type Far End Opr I.Label E.Label
-----------+-------------------+-------+--------------+------+--------+--------
100 10:100 Mesh 10.11.0.6 Up 131069 131070
200 30:200 Mesh 30.1.2.3 Down 0 0
Number of SDPs : 2
-> show service sdp-using 10
Service Destination Point (Sdp Id : 10:0)
SvcId SdpId Type Far End Opr I.Label E.Label
-----------+-------------------+-------+--------------+------+--------+--------
100 10:100 Mesh 10.11.0.6 Up 131069 131070
Number of SDPs : 1