Alcatel-Lucent 6850-48 Reference Guide

Ethernet OAM Commands

OmniSwitch CLI Reference Guide

page 28-33

Configures the timer value for the Fault Notification Generation Reset time that specifies the time inter-
val, during which the fault alarm is re-enabled to process faults. The fault alarm will only be re-enabled if 
no new faults are received during this time interval.

ethoam fault-reset-time centiseconds endpoint endpoint_id domain {mac_address | domain_name}         
association association_name

no ethoam fault-reset-time endpoint endpoint_id domain {mac_address | domain_name} association 
association_name

The Fault Notification Generation Reset timer value, in centi seconds. 
The valid range is 250–1000.

Specifies the MEP of a specific MA. The valid range is 1–8191.

Specifies the CFM system MAC address.

Specifies the domain name. For more information on the different 
formats of the domain name, refer to 

Name of the Ethernet OAM Association. Up to 48 (minus the domain 
name length) characters may be used.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of this command to to restore the Fault Notification Generation Reset timeout value to 

its default value.

• The Fault Notification Generation Reset timer value is configurable per MEP.

-> ethoam fault-reset-time 10 end-point 100 domain esd.alcatel-lucent.com associa-

tion alcatel_sales

-> no ethoam fault-reset-time end-point 100 domain esd.alcatel-lucent.com associa-

tion alcatel_sales

1000