Alcatel-Lucent 6850-48 Reference Guide

IS-IS Commands

OmniSwitch CLI Reference Guide

page 43-23

Configures the IS-IS router to be in the overload state after bootup for a specified time period.

ip isis overload-on-boot [timeout seconds]

no ip isis overload-on-boot [timeout seconds]

timeout seconds

Specifies the timeout interval, in seconds. The valid range is 60–1800.

By default, the IS-IS router will not be in the overload state.

OmniSwitch 6850, 9000, 9000E

• Use the no form of this command to prevent the router from entering the overload state after bootup.

• The router in the overload state is used only if there is no alternate path to reach the destination.

• This command configures the router after bootup in the overload state until the timeout timer expires or 

a timeout value is specified in the no form of this command.

• The no overload command does not influence the overload-on-boot function.

-> ip isis overload-on-boot timeout 80

-> no ip isis overload-on-boot timeout

Release 6.2.1; command was introduced.
Release 6.3.1; support for OmniSwitch 9000 added.

timeout seconds

60