Alcatel-Lucent 6850-48 Reference Guide
PIM Commands
OmniSwitch CLI Reference Guide
September 2009
page 45-27
ip pim state-refresh-limit
Sets the limit at which a router will not forward successive State Refresh messages if they are received at
less than the interval.
less than the interval.
ip pim state-refresh- limit ticks
Syntax Definitions
ticks
The limit at which the received State Refresh messages will not be
forwarded, if the messages are received at less than the interval. Values
may range from 0 to 65535.
forwarded, if the messages are received at less than the interval. Values
may range from 0 to 65535.
Defaults
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
• This command is supported only in the dense mode.
• This value is used with both IPv4 and IPv6.
Examples
-> ip pim state-refresh-limit 2
Release History
Release 6.1.1; command was introduced.
Related Commands
MIB Objects
alaPimdmGlobalConfig
alaPimdmStateRefreshLimitInterval
parameter
default
ticks
0
Enables or disables the PIM protocol on a specific interface.
Enables IPv6 PIM and configures the statistics.
Displays the status of the various global parameters for the PIM
dense mode.
dense mode.
Displays the status of the various global parameters for the IPv6
PIM dense mode.
PIM dense mode.