Alcatel-Lucent 6850-48 Reference Guide
DVMRP Commands
page 46-30
OmniSwitch CLI Reference Guide
September 2009
show ip dvmrp neighbor
Displays the DVMRP neighbor table. The DVMRP neighbor table displays either all neighboring DVMRP
routers, or a specified neighboring DVMRP router.
routers, or a specified neighboring DVMRP router.
show ip dvmrp neighbor [ip_address]
Syntax Definitions
ip_address
Specifies a particular IP address for a neighboring DVMRP router.
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
If a neighbor IP address is not specified, the entire DVMRP Neighbor Table is displayed.
Examples
-> show ip dvmrp neighbor
Neighbor Address Intf Name Uptime Expires GenID Vers State
----------------+-------------+-----------+-----------+----------+------+-------
143.209.92.214
vlan-2
00h:09m:12s 00h:00m:06s 546947509 3.255
active
Release History
Release 6.1; command was introduced.
output definitions
Neighbor Address
The 32-bit IP address of the DVMRP neighbor’s router interface.
Itnf Name
The interface name of the neighbor’s router.
Uptime
The amount of time the neighbor has been running, displayed in hours,
minutes, and seconds.
minutes, and seconds.
Expires
The amount of time remaining before the neighbor expires, displayed in
hours, minutes, and seconds.
hours, minutes, and seconds.
GenID
The generation ID for the DVMRP neighbor. This value is used by
neighboring routers to detect whether the DVMRP routing table should
be resent.
neighboring routers to detect whether the DVMRP routing table should
be resent.
Version
The DVMRP version number for the neighbor.
State
The current state of the DVMRP neighbor. Options include active and
down.
down.