Alcatel-Lucent 6850-48 Reference Guide
Multicast Routing Commands
OmniSwitch CLI Reference Guide
September 2009
page 47-5
ipv6 mroute-boundary
Configures or deletes an IPv6 multicast boundary on the interface for a specified scope zone. Packets with
a destination address in the associated address/mask range will not be forwarded over the boundary inter-
face.
a destination address in the associated address/mask range will not be forwarded over the boundary inter-
face.
ipv6 mroute-boundary if_name scope scope_value
no ipv6 mroute-boundary if_name scope scope_value
Syntax Definitions
if_name
The interface name on which the boundary is being assigned.
scope_value
The scope value indicates the scope of the IPv6 internetwork for which
the multicast traffic is intended. Range of scope value is 3-15.
the multicast traffic is intended. Range of scope value is 3-15.
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
• Use the no form of this command to delete the configured IPv6 scoped multicast address boundaries
for a router interface.
• IPMRM must be configured on the switch.
Examples
-> ipv6 mroute-boundary vlan-2 scope 6
Release History
Release 6.3.4; command was introduced.
Related commands
MIB Objects
ipMcastBoundaryTable
ipMcastBoundaryIfIndex
ipMcastBoundaryAddressType
ipMcastBoundaryAddress
ipMcastBoundaryAddressPrefixLength
Displays information about the IPv6 scoped multicast boundaries
that have been defined on the system.
that have been defined on the system.