Alcatel-Lucent 6850-48 Reference Guide
sFlow Commands
page 51-4
OmniSwitch CLI Reference Guide
September 2009
sflow receiver
Sets the destination hosts where the sFlow datagrams are sent out. If there are multiple destinations, then
each destination is associated with the receiver instance. All these destinations are attached to the sFlow
manager instance and to an associated sampler/poller.
each destination is associated with the receiver instance. All these destinations are attached to the sFlow
manager instance and to an associated sampler/poller.
sflow receiver num name string timeout {seconds | forever} address {ip_address | ipv6address} udp-
port port packet-size size Version num
port port packet-size size Version num
sflow receiver receiver_index release
Syntax Definitions
num
Specifies the receiver index.
string
Specifies the name.
seconds | forever
Specifies the timeout value.
ip_address| ipv6address
Specifies the 32/128-bit ip address.
port
Specifies the UDP (destination) port.
size
Specifies the maximum number of data bytes (size) that can be sent.
num
Specifies the version number.
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
Use the release form at the end of the command to delete a receiver.
Examples
-> sflow receiver 1 name Golden address 198.206.181.3
-> sflow receiver 1 release
parameter
default
string
empty
seconds
0
ip_address
0.0.0.0(ipv4)
port
6343
size
1400
version num
5