Alcatel-Lucent 6850-48 Reference Guide
sFlow Commands
page 51-10
OmniSwitch CLI Reference Guide
September 2009
show sflow agent
Displays the sflow agent table.
show sflow agent
Syntax Definitions
agent
Collects sample datagrams and send it to the collector across the
network.
network.
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
command to make a Loopback0 IP address as the fixed
primary address of the switch, in order to avoid interface changes, which might need the collector soft-
ware to be restarted for it to communicate using the new agent IP address. Normally, the primary IP
address could change depending on the IP interface going up/down. Therefore, the sFlow agent always
needs to send a fixed IP address in the datagram.
ware to be restarted for it to communicate using the new agent IP address. Normally, the primary IP
address could change depending on the IP interface going up/down. Therefore, the sFlow agent always
needs to send a fixed IP address in the datagram.
• The loopback address should be an IP interface configured on the switch.
Examples
-> ip interface Loopback0 address 198.206.181.100
-> show sflow agent
Agent Version = 1.3; Alcatel-Lucent; 6.1.1
Agent IP = 198.206.181.100
Release History
Release 6.1.1; command was introduced.
Related Commands
output definitions
Agent Version
Identifies the version which includes the MIB version, organization
name, and the specific software build of the agent.
name, and the specific software build of the agent.
Agent address
IP address associated with the agent.
Displays the receiver table.