Alcatel-Lucent 6850-48 Reference Guide

QoS Commands

OmniSwitch CLI Reference Guide

page 52-21

Enables or disables the automatic prioritization of IP phone traffic.

qos phones [priority priority_value | trusted]

The priority given to scheduling traffic on the output port. Values range 
from 0 (lowest) to 7 (highest).

Trusts IP phone traffic; priority value of the IP phone packet is used.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of this command to disable automatic prioritization of IP phone traffic.

• IP phone traffic is identified by examining the source MAC address of the packet received on the port. 

If the source MAC falls within one of the following ranges, the QoS IP phone priority is automatically 
assigned to the MAC:

00-80-9F-54-xx-xx to 00-80-9F-64-xx-xx 
00-80-9F-66-xx-xx to 00-80-9F-6F-xx-xx.

• To automatically apply the QoS IP phone priority to other, non-IP phone traffic, add the source MAC 

addresses of such traffic to the QoS “alaPhone” group. 

• When automatic prioritization of IP phone traffic is enabled, QoS policies that specify priority are not 

applied to the IP phone traffic. Other QoS policies, however, are applied to this type of traffic as usual.

-> qos phones priority 7

-> qos phones trusted

-> qos no phones

Release 6.3.1; command was introduced.

priority_value | trusted

trusted