Alcatel-Lucent 6850-48 Reference Guide

QoS Policy Commands

OmniSwitch CLI Reference Guide

page 53-137

Configures a Type of Service (ToS) bits value to be applied to packets in outgoing flows to which the 
specified policy applies.

policy action action_name tos tos_value 

policy action action_name no tos

The name of the action.

The three-bit priority value in the IP header that should be set on outgo-
ing frames in flows that match the specified policy. Values range from 0 
(lowest priority) to 7 (highest priority).

N/A

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of this command to remove a ToS value from a policy action.

• Note that specifying both ToS and DSCP in the same action is not allowed.

-> policy action action3 tos 4

-> policy action action3 no tos

Release 6.1; command was introduced.

Applies configured QoS and policy settings to the current configuration. 

Creates a policy action.

Displays information about policy actions.