Alcatel-Lucent 6850-48 Reference Guide

IP Multicast Switching Commands

page 55-48

OmniSwitch CLI Reference Guide

Enables or disables MLD querier forwarding on the specified VLAN or on the system if no VLAN is spec-
ified.

ipv6 multicast [vlan vid] querier-forwarding [{enable | disable}]

no ipv6 multicast [vlan vid] querier-forwarding

The VLAN on which configuration is applied.

Enable MLD querier forwarding.

Disable MLD querier forwarding.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of this command to remove an MLD querier forwarding entry on the specified VLAN 

or on the system and return to its default behavior.

• If the MLD querier forwarding is already enabled on the system, then the VLAN configuration will 

override the system's configuration.

• MLD querier forwarding refers to promoting detected MLD queriers to receive all IP multicast data 

traffic.

-> ipv6 multicast querier-forwarding enable

-> ipv6 multicast querier-forwarding disable

-> ipv6 multicast querier-forwarding

-> ipv6 multicast vlan 2 querier-forwarding enable

-> ipv6 multicast vlan 2 querier-forwarding disable

-> ipv6 multicast vlan 2 querier-forwarding

-> no ipv6 multicast vlan 2 querier-forwarding

Release 6.3.1; command was introduced.

enable | disable