Alcatel-Lucent 6850-48 Reference Guide

CMM Commands

page 1-2

OmniSwitch CLI Reference Guide

Reboots the CMM to its startup software configuration.

reload [primary | secondary] [with-fabric] [in [hours:] minutes | at hour:minute [month day | day 
month]]

Reboot the primary or secondary CMM to its startup software 
configuration. If the primary CMM is already running the startup 
version, a primary reboot will result in a secondary takover.

Performs a complete CMM reload. This parameter is available only on 
OmniSwitch chassis-based series switches.

in [hours:] minutes

Optional syntax. Schedules a reload of the software to take effect in the 
specified minutes or hours and minutes within the next 24 hours.

at hour:minute

Optional syntax. Schedules a reload of the software to take place at the 
specified time using a 24-hour clock. If you do not specify the month 
and day, the reload takes place at the specified time on the current day 
provided the specified time is later than the time when the CLI 
command is issued. If the specified time is earlier than the current time, 
the reload will take place on the following day.

month day | day month

The name of the month and the number of the day for the scheduled 
reload. Specify a month name and the day number. It is unimportant if 
the month or day is first. See examples below for further explanation.

Cancels a pending time delayed reboot.

N/A

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• This command causes the specified CMM to reboot. If no CMM is specified, the primary CMM 

reboots.

• The CPM, CFM and CPU of CMM can be reset independently.

• If a reload command is issued and the local/remote fabric module is in up state, only the CPM will be 

reset. 

• If a reload command is issued and the local/remote fabric module is in a down state, then the complete 

CMM will be reloaded.