Alcatel-Lucent 6850-48 Reference Guide

Distributed Spanning Tree Commands

page 15-96

OmniSwitch CLI Reference Guide

• Configure ports that will connect to a host (PC, workstation, server, etc.) as edge ports to avoid unnec-

essary topology changes when these ports go active. This will also prevent the flushing of learned 
MAC addresses on these ports if a topology change occurs as a result of another non-edge port going 
active. If an edge port receives a BPDU, it will operationally revert back to a no point to point connec-
tion type. 

-> bridge mode flat

-> bridge 1x1 4 15 admin-edge on

-> bridge 1x1 255 8/23 admin-edge disable

-> bridge mode 1x1

-> bridge 1x1 3 2/2 admin-edge enable

-> bridge 1x1 255 10 admin-edge off

Release 6.1.3; command was introduced.

vStpInsPortTable

vStpInsPortNumber

vStpInsPortAdminEdge

Selects the Spanning Tree operating mode (flat or 1x1) for the switch

Configures the administrative edge port status for a port or aggregate 
of ports for the CIST instance.

Configures whether or not Spanning Tree automatically determines the 
operational edge status of a port or an aggregate of ports for the CIST 
instance.

Configures whether or not Spanning Tree determines the operational 
edge port status for a port or an aggregate of ports for the specified 1x1 
mode VLAN instance.