Alcatel-Lucent 6850-48 Reference Guide

Ethernet Port Commands

page 19-46

OmniSwitch CLI Reference Guide

Configures port crossover settings on a single port, a range of ports, or an entire Network Interface (NI).

interfaces slot[/port[-port2]] hybrid copper crossover {auto | mdix | mdi}

Slot number you want to configure.

Port number of the interface you want to configure.

Last port number in a range of ports you want to configure.

Specifies that changes will be made to the copper 10/100/1000 RJ-45 
port(s).

The interface will automatically detect crossover settings.

Sets the crossover configuration to Media Dependent Interface with 
Crossover (MDIX), which is the standard for hubs and switches.

Sets the crossover configuration to Media Dependent Interface (MDI), 
which is the standard for end stations.

OmniSwitch 6400, 6850, 6855

• Refer to the Hardware Users Guide for combo port numbering. 

• You cannot configure crossover settings on fiber ports. These ports use the MDI standard.

• The MIB table and MIB object listed in the “MIB Objects” section below apply to the inactive config-

ured media only. See the “MIB Objects” section in the 

 section for the MIB table 

and MIB object for the active configured media.

-> interfaces 1/47 hybrid copper crossover disable

-> interfaces 1/47-48 hybrid copper crossover mdix

-> interfaces hybrid copper crossover auto

Release 6.1; command was introduced.