Alcatel-Lucent 6850-48 Reference Guide

VLAN Management Commands

page 21-20

OmniSwitch CLI Reference Guide

Displays VLAN port associations (VPAs) for all VLANs, a specific VLAN, or for a specific port. Infor-
mation is also included that shows the VPA type (configured default VLAN, 802.1Q tagged VLAN, 
dynamically assigned secondary VLAN, or mirrored port VLAN assignment) and the status of that associ-
ation (inactive, blocking, forwarding, or filtering).

show vlan [vid1[-vid2]] port [slot/port | link_agg]

VLAN ID number (1–4094).

The last VLAN ID number in a range of VLANs that you want to 
configure (e.g. 10-12 specifies VLANs 10, 11, and 12).

Enter the slot number for the module and the physical port number on 
that module (e.g. 3/1 specifies port 1 on slot 3). 

Enter the link aggregate ID number (0–31) to assign to the specified 
VLAN.

If no parameters are specified with this command, a list of all VLANs and their assigned ports is displayed 
by default.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• If the vid is specified without a slot/port or link_agg, then all port assignments for that VLAN are 

displayed.

• If the slot/port or link_agg is specified without a vid, then all VLAN assignments for that port are 

displayed.

• If both the vid and slot/port or link_agg are specified, then information only for that VLAN and slot/

port or link aggregate ID is displayed.

• Note that specifying a range of VLAN IDs is also allowed. Use a hyphen to indicate a contiguous range 

(e.g., show vlan 10-15 port). Note that only one VLAN entry—a single VLAN ID or a range of VLAN 
IDs— is allowed with this command. Multiple entries are not accepted.

-> show vlan port

vlan   port     type      status

+-----+-------+---------+------------+

1      1/1 

default   inactive

2      1/2 

default   blocking

1/3 mobile forwarding

11/4 qtagged 

forwarding