Alcatel-Lucent 6850-48 Hardware Manual
OmniSwitch 6850-48
OmniSwitch 6850 Series Chassis and Hardware Components
page 2-28
OmniSwitch 6850 Series Hardware Users Guide
September 2009
Refer to the illustration below for more front panel information. For detailed LED descriptions, refer to
. For information on the chassis rear panel, refer to
.
OmniSwitch 6850-48 Front Panel
10/100/1000Mbps
The OS6850-48 provides 44 fixed 10/100/1000BaseT
(5–48) and 4 fixed 10/100/1000BaseT combo (1–4).
These are auto-sensing and auto-MDIX and use RJ-45
connectors.
The OS6850-48 provides 44 fixed 10/100/1000BaseT
(5–48) and 4 fixed 10/100/1000BaseT combo (1–4).
These are auto-sensing and auto-MDIX and use RJ-45
connectors.
Console Port
The OS6850-48 front panel provides one
RJ-45 port for console connections. Con-
sole connections are used by network
administrators for switch management.
This female RJ-45 connector provides a
DTE console connection.
The OS6850-48 front panel provides one
RJ-45 port for console connections. Con-
sole connections are used by network
administrators for switch management.
This female RJ-45 connector provides a
DTE console connection.
Status and Slot Indicator LEDs
For detailed information on OS6850-48
status and slot indicator LEDs, refer to
For detailed information on OS6850-48
status and slot indicator LEDs, refer to
.
OmniSwitch 6850-48
USB
Console
OK
PRI
PWR
BPS
CLASS 1 LASER PRODUCT
1 2 3 4
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48
USB Port
High speed (480 Mbps) USB 2.0
port, which can be used for quick
upgrades.
High speed (480 Mbps) USB 2.0
port, which can be used for quick
upgrades.
Combo SFP
The OS6850-48 provides four combo SFP connectors for 1000Base-X high-
speed connections.
The OS6850-48 provides four combo SFP connectors for 1000Base-X high-
speed connections.
By default, when an SFP is installed in a combo port, it takes over the port num-
ber of the corresponding RJ-45 Ethernet port. In other words, if an SFP is
installed in the slot labeled 4, Ethernet port 4 is no longer available and cannot
be used for 10/100/1000 traffic. This default setting is referred to as “preferred
fiber.” Refer to “Configuring Ethernet” in the Network Configuration Guide for
detailed information, including steps for configuring combo port settings.
ber of the corresponding RJ-45 Ethernet port. In other words, if an SFP is
installed in the slot labeled 4, Ethernet port 4 is no longer available and cannot
be used for 10/100/1000 traffic. This default setting is referred to as “preferred
fiber.” Refer to “Configuring Ethernet” in the Network Configuration Guide for
detailed information, including steps for configuring combo port settings.