Alcatel-Lucent ls 6248 User Guide
Configuring the Switch
128
3
Figure 3-55. Alarm Page
CLI – The following is an example of the CLI commands used to set RMON alarms:
Alcatel Mapping Adjacency Protocol (AMAP)
The AMAP protocol enables a switch to discover the topology of other AMAP-aware
devices in the network. The protocol allows each switch to determine if other
AMAP-aware switches are adjacent to it. Note that two switches are adjacent if and
only if the following two requirements are satisfied:
• There exists a Spanning Tree path between them.
devices in the network. The protocol allows each switch to determine if other
AMAP-aware switches are adjacent to it. Note that two switches are adjacent if and
only if the following two requirements are satisfied:
• There exists a Spanning Tree path between them.
• There exists no other AMAP-aware device between the two switches on that
Spanning Tree path.
Configuring AMAP
The AMAP protocol discovers adjacent switches by sending and receiving AMAP
Hello packets on active Spanning Tree ports. Each port can be defined as being in
one of three logical states of processing the AMAP Hello Packets: discovery,
common, or passive.
Hello packets on active Spanning Tree ports. Each port can be defined as being in
one of three logical states of processing the AMAP Hello Packets: discovery,
common, or passive.
Note:
AMAP packets are registered only on a default VLAN.
Use the AMAP Settings Page to enable/disable AMAP and configure timeout
Console(config)# rmon alarm 1000 1.3.6.1.2.1.10.7.2.1.3.51 1000000
1000000 10 20 1