Alcatel-Lucent ls 6248 User Guide

Configuring the Switch

218

3

• Copy from Entry Number — Indicates the row number from which GARP 

parameters are copied.

• To Entry Number — Indicates the row number to which GARP parameters are 

copied.

• Interface — Displays the port or LAG on which GARP is enabled. 

• Join Timer— Indicates the amount of time, in centiseconds, that PDUs are 

transmitted. The default value is 20 centiseconds.

• Leave Timer— Indicates the amount of time lapse, in centiseconds, that the 

device waits before leaving its GARP state. Leave time is activated by a Leave All 
Time message sent/received, and cancelled by the Join message received. Leave 
time must be greater than or equal to three times the join time. The default value 
is 60 centiseconds. 

• Leave All Timer — Indicates the amount of time lapse, in centiseconds, that all 

device waits before leaving the GARP state. The leave all time must be greater 
than the leave time. The default value is 1000 centiseconds.

Web – Click Layer 2, VLAN, GARP. Enable or disable GARP, and click Apply.

CLI – The following is an example of the GARP configuration commands:

Console(config)# 

1/e6

Console(config-if)# 

900