Alcatel-Lucent ls 6248 User Guide
Configuring Quality of Service
239
3
Web – Click Policy, General QoS, Bandwidth Configuration. Define the fields, and
click Apply.
click Apply.
Figure 3-119. Bandwidth Configuration Page
CLI – The following is an example of the CLI commands used to configure traffic
shaping:
shaping:
Configuring VLAN Rate Limit
Rate limiting per VLAN allows network administrators to limit traffic on VLANs. Rate
limiting is calculated separately for each unit in a stack, and for each packet
processor in a unit. QoS rate limiting has priority over VLAN rate limiting. For
example, if a packet is subject to QoS rate limits but is also subject to VLAN rate
limiting, and the rate limits conflict, the QoS rate limits take precedence.
Command Attributes
• VLAN – Indicates the VLAN on which the Rate Limit is applied
limiting is calculated separately for each unit in a stack, and for each packet
processor in a unit. QoS rate limiting has priority over VLAN rate limiting. For
example, if a packet is subject to QoS rate limits but is also subject to VLAN rate
limiting, and the rate limits conflict, the QoS rate limits take precedence.
Command Attributes
• VLAN – Indicates the VLAN on which the Rate Limit is applied
• Rate Limit – Defines the maximum rate (CIR) in kbits per second (bps) that
forwarding traffic is permitted in the VLAN.
• Burst Size – Defines the maximum burst size (CbS) in bytes that forwarding traffic
is permitted through the VLAN.
Web – Click Policy, General QoS, VLAN Rate Limit, and Add. Define the fields, and
click Apply.
click Apply.
Console(config)# interface ethernet 1/e5
Console(config-if) traffic-shape 124000 96000