Alcatel-Lucent ls 6248 User Guide
Configuring the Switch
212
3
Figure 3-103. Customer Multicast TV VLAN Page
CLI – The following is an example of the Customer Multicast TV VLAN CLI
commands:
commands:
Mapping CPE VLANs
Network managers can map CPE VLANs to Multicast TV VLANs in the CPE VLANs
Mapping Page. Once the CPE VLAN is mapped to the Multicast VLAN, the VLAN
can participate in IGMP snooping.
Mapping Page. Once the CPE VLAN is mapped to the Multicast VLAN, the VLAN
can participate in IGMP snooping.
Note:
Configure Triple play only in the following order:
1.
Configure the port as QinQ see parameter Interface VLAN Mode on the
.
2.
Add the port to the Multicast TV LAN see Multicast TV Membership Page.
3.
Configure the port as Triple Play see
.
Command Attributes
• CPE VLAN — Indicates the CPE VLAN which is mapped to the Multicast TV VLAN.
• Multicast TV VLAN — Indicates the CPE VLAN which is mapped to the Multicast
TV VLAN.
• Remove — Removes the CPE VLAN to Multicast TV VLAN mapping the possible
field values are:
• Checked — Removes the selected CPE VLAN to Multicast TV VLAN mapping.
Console(config-if)# switchport customer multicast-tv vlan add 20