Fujitsu s300 Quick Setup Guide

ScanSnap S300 Getting Started　

32

This chapter describes how to clean the ScanSnap.

*1) It may take long before the cleaner vaporizes if a large quantity is used. When 

cleaning the scanner parts, dampen a cloth with modest quantities of the cleaner. In 
addition, wipe off the cleaner completely with a soft lint-free cloth to leave no residue 
on the surface of the cleaned parts.

*2) Pre-moistened with Cleaner F1, Cleaning Wipes are used instead of moistened cloths.

To purchase the cleaning material, contact the store where you purchased the scanner or 
an authorized FUJITSU scanner service provider.

Clean the scanner exterior with a cloth moistened with a small amount of neutral 
detergent or Cleaner F1 (sold separately).

• Before cleaning the scanner, turn the scanner OFF to prevent fire or 

electric shock. 

• To avoid injuries, do not place the internal parts (such as the Pad 

ASSY and Pick roller) in areas where small children can reach.

Cleaner F1

PA03950-0352

1 bottle (100 ml) (*1)

Cleaning wipe

PA03950-0419

1 pack (24 sheets) (*2)

ATTENTION

• Never use paint thinner or other organic solvents.
• During the cleaning, prevent water or moisture from getting inside the 

scanner.

• Do not use aerosol sprays to clean the scanner. Aerosol sprays cause 

dirt and dust to enter the scanner, resulting in scanner failure or 
malfunction, or errors in scanned images.