Fujitsu s300 Service Manual
2.2 Connecting the ScanSnap to your PC
ScanSnap S300 Operator's Guide
15
Connecting t
he ScanSnap
2
2.2
Connecting the ScanSnap to your PC
When the installation of the above programs is complete, connect the ScanSnap to your computer.
■ Connecting the Cable
Connect the ScanSnap to a power supply in either of two ways below:
First, connect to a power supply, and then connect to a personal computer with the USB cable.
First, connect to a power supply, and then connect to a personal computer with the USB cable.
ATTENTION
Be sure to install the supplied programs, and then restart your computer before
connecting the ScanSnap to your computer with cables. (For details about the
installation, refer to
connecting the ScanSnap to your computer with cables. (For details about the
installation, refer to
).
Power source
Use the following cable:
See:
Power outlet
(When always operating
the scanner at the same
regular place where it
can be fed power from a
power outlet)
the scanner at the same
regular place where it
can be fed power from a
power outlet)
Personal computer
(When using the
scanner at a place
where it reaches no
power outlet, or when
carrying the scanner
together with your laptop
computer around and
operating at a place
where no power outlet is
available)
scanner at a place
where it reaches no
power outlet, or when
carrying the scanner
together with your laptop
computer around and
operating at a place
where no power outlet is
available)
CAUTION
Use only the AC cable and AC adapter (power cable) below:
Otherwise, a failure may be caused.
Otherwise, a failure may be caused.
•
Manufacturer: LEI
•
Model No.: NU13-1072166-I3
The Power cable
is a combination of
the AC adapter
and AC cable.
is a combination of
the AC adapter
and AC cable.
Power cable
USB bus power
cable
cable