BTC 2003rf Installation Instruction
2003RF Quick Installation Guide
3100505740 v.1.0
Wireless Keyboard & Mouse Kit
Quick Installation Guide
Hardware Installation
Slide Switch Setting
Mouse Connector Keyboard Connector
ID Button
1.5V 2pcs
1.
Make sure your PC is switched off.
2. Connect the receiver to your PC by plugging in the
receiver’s green connector into the mouse port of
your PC and the purple connector into the keyboard
port.
your PC and the purple connector into the keyboard
port.
3. Take the keyboard and make sure the batteries on
the back are installed correctly. (Follow the polarity
signs in the battery compartment.)
signs in the battery compartment.)
4. Take the mouse and make sure the batteries on the
back are installed correctly. (Follow the polarity
signs in the battery compartment.)
signs in the battery compartment.)
ID Button Setting
ID Button
This ID-recognition function helps to protect against
interference from other RF keyboards in the same
environment. Remember to set the ID when you replace
the batteries or your keyboard kits do not work
properly.
The word CONNECT labels the ID button on each unit.
interference from other RF keyboards in the same
environment. Remember to set the ID when you replace
the batteries or your keyboard kits do not work
properly.
The word CONNECT labels the ID button on each unit.
1.
Your PC must be on to change the ID setting.
2.
Press ID button on the side of the receiver once.
3.
Press ID button on the bottom of the mouse once
4. Press ID button on the bottom of the keyboard
once.
ID Button
1.5V 2pcs
Software Installation
Keyboard Driver Installation
In order to take advantage of the special button functionality of the keyboard you will have to install
the keyboard driver which is located on the driver CD included in the box.
the keyboard driver which is located on the driver CD included in the box.
1. Insert the driver CD into your drive.
2. Run
2. Run
the
SetupKey.exe in the \2003RF&2001ARF\keyboard software directory of the driver CD.
3. Follow the on screen instructions to finish the installation procedure.
Mouse Driver Installation
In order to take advantage of the special shortcut button functionality of the mouse you will have to
install the mouse driver which is located on the driver CD included in the box.
install the mouse driver which is located on the driver CD included in the box.
1.
Insert the driver CD into your drive.
2.
Run the setup.exe in the \2003RF&2001ARF\mouse software directory of the driver CD.
3. Follow the on screen instructions to finish the installation procedure.
ID Button of
Keyboard
ID Button of
Receiver
ID Button of
Mouse