Amazon kindle touch User Guide

Page of 27
 
Kindle User’s Guide 
24
 
Appendix A Product Information
Watch for Signs
There are some places where RF signals could constitute a hazard, such as health care 
facilities, and construction sites. If you are not sure, look around for signs indicating that two-
way radios or cell phones should be turned off.
In addition, turn off and do not charge your device if you are in any area with a potentially 
explosive atmosphere, as sparks in such areas could cause an explosion or fire. Such areas 
are usually, but not always, clearly identified, and include areas where you would normally be 
advised to turn off your vehicle engine.
FCC Compliance Statement
The Devices comply with part 15 of the FCC rules. Operation is subject to the following two 
conditions: (1) The Devices may not cause harmful interference; and (2) the Devices must 
accept any interference received, including interference that may cause undesired operation.
The Devices have been tested and found to comply with the limits for a Class B digital 
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. However, there is no 
guarantee that interference will not occur in a particular installation.
The Devices meet the FCC Radio Frequency Emission Guidelines and are certified with the 
FCC as the FCC ID number found on the back of the Device.
Changes or modifications not expressly approved by the party responsible for compliance 
could void the user’s authority to operate the equipment.
Information Regarding Exposure to Radio Frequency Energy
Your Device is designed and manufactured not to exceed the emission limits for exposure 
to RF energy set by the Federal Communications Commission of the United States (FCC). 
Information on your Device is on file with the FCC and can be found under the Display Grant 
section of 
 after searching on the FCC ID for your Device, 
which can be found on the back of the Device.
IEEE 1725 Battery Safety Statement
•  Do not disassemble or open, crush, bend or deform, puncture or shred.
•  Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse
or expose to water or other liquids, expose to fire, explosion or other hazard.
•  Only use the battery for the system for which it is specified.
•  Only use the battery with a charging system that has been qualified with the system per
this standard. Use of an unqualified battery or charger may present a risk of fire, explosion, 
leakage, or other hazard.
•  Do not short circuit a battery or allow metallic conductive objects to contact battery terminals.
•  Replace the battery only with another battery that has been qualified with the system per
this standard, IEEE-Std-1725-200x. Use of an unqualified battery may present a risk of fire, 
explosion, leakage or other hazard.
•  Promptly dispose of used batteries in accordance with local regulations.
•  Avoid dropping the device or battery. If the device or battery is dropped, especially on a hard
surface, and the user suspects damage, take it to a service center for inspection.