Printronix SL4M User Manual

246

Printronix makes no representations or warranties of any kind regarding this 
material, including, but not limited to, implied warranties of merchantability 
and fitness for a particular purpose. Printronix shall not be held responsible 
for errors contained herein or any omissions from this material or for any 
damages, whether direct, indirect, incidental or consequential, in connection 
with the furnishing, distribution, performance or use of this material. The 
information in this manual is subject to change without notice.

This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses, and can radiate radio 
frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or 
more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

Unauthorized changes or modifications could void the user’s authority to 
operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to 
the following two conditions: (1) this device may not cause harmful 
interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation.

Any change or modification to this product voids the user’s authority to 
operate it per FCC Part 15 Subpart A Section 15.21 regulations.

To comply with FCC and IC RF exposure requirements, the device is 
approved for operation with a minimum separation distance of 20cm for all 
persons.

To comply with FCC part 15C and IC RSS 210 requirements, the device must 
not be co-located or operating in conjunction with any other transmitter or 
antenna other than those allowed by Printronix for this device.