Toshiba RD-X2U Owner's Manual

Page of 200
3
Intr
oduction
Connections
Basic Setup
Note to CATV system installer:
This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected
to the grounding system of the building , as close to the point of cable entry as practical.
Copyright
It is permissible to record television programs, film, video tapes and other material only in the event
that third party copyrights and other rights are not violated.
The instructions shall state that an ALL-POLE MAINS SWITCH with a contact separation of at least 3 mm in
each pole shall be incorporated in the electrical installation of the building.
CAUTION:
These servicing instructions are for use by qualified service personnel only. To reduce the risk
of electric shock do not perform any servicing other than that contained in the operating
instructions unless you are qualified to do so.
In the spaces provided below, record the Model and Serial No. located on the rear panel of your recorder.
Model No.
Serial No.
Retain this information for future reference.
Location of the required label
PRODUCT IS CERTIFIED BY THE MANUFACTURER TO
COMPLY WITH DHHS RULE 21 CFR SUBCHAPTER J
APPLICABLE AT THE DATE OF MANUFACTURE.
1-1,SHIBAURA 1-CHOME,MINATO-KU.
MANUFACTURED
            TOKYO 105-8001,JAPAN
RD-X2U.Prep.(E)p02-12
9/3/02, 9:47 AM
3