Toshiba M400 User Guide

Page of 255
User’s Manual
3-7
Getting Started
Do not expose the computer to rapid temperature changes (such as 
would be the case if you brought the PC from a cold environment into a 
warm room). When rapid temperature changes are unavoidable, leave 
the computer for around two hours before turning it on to prevent the 
formation of condensation.
Remove all external peripheral devices and their connection cables 
from the computer before carrying. 
Do not drop the computer or apply excessive impact to it. Do not leave 
the computer in a car or similar environment where it is exposed to 
direct sunlight.
Do not put the computer in a bag when it is in tablet mode.
The display panel works as a touch sensitive digitizer screen. However, 
the outer edges of the screen may be less sensitive. Please keep the 
Tablet PC Pen inside the display area when you use it near the edges of 
the display panel. The position of the pen may not be recognized if you 
move the Tablet PC Pen too fast towards the outer edge. Please be 
sure to slide the Tablet PC Pen slowly in areas near the edges of the 
screen.
Use the Tablet PC Pen in the areas enclosed by the dotted line as 
shown in the following figure.
Use area of a Tablet PC Pen
Connecting the AC adaptor
Attach the AC adaptor when you need to charge the battery or you want to 
operate from AC power. It is also the fastest way to get started, because 
the battery pack will need to be charged before you can operate from 
battery power.
The AC adaptor can be connected to any power source supplying from 100 
to 240 volts and 50 or 60 hertz. For details on using the AC adaptor to 
charge the battery pack, refer to Chapter 6, 
.
Do not block the vent of the computer when holding it. If you continue to 
expose your skin to the hot air expelled from the vent for a long time, your 
skin might suffer low temperature injury.