Toshiba P10-792 User Guide
Power and Power-Up Modes
Satellite P10 Series
6-12
Satellite P10 Series
Version
1
Last Saved on 26/08/2003 14:06
ENGLISH using Euro_M.dot –– Printed on 26/08/2003 as IM_P10EN
Installing the battery pack
To install a battery pack, follow the steps below.
The battery pack is a lithium ion battery, which can explode if not properly
replaced, used, handled or disposed of. Dispose of the battery as required
by local ordinances or regulations. Use only batteries recommended by
TOSHIBA as replacements.
replaced, used, handled or disposed of. Dispose of the battery as required
by local ordinances or regulations. Use only batteries recommended by
TOSHIBA as replacements.
1.
Turn the computer’s power off.
2.
Disconnect all cables connected to the computer.
3.
Hold the battery pack so that the label faces down and the
connectors on the battery face the connectors on the computer.
connectors on the battery face the connectors on the computer.
4.
Gently press the battery into the battery bay until the latch clicks into
place.
place.
Installing the battery pack
Power-up modes
The computer has three power-up modes:
■
Hibernation (saves data in memory to the hard disk)
■
Standby (Power remains on, saving data in RAM, but the CPU and all
other devices enter sleep mode.)
other devices enter sleep mode.)
■
Boot (does not save data in memory)
Refer also to the section Turning off the power in Chapter 3, Getting
Started.
Started.