Aiptek hi-speed hd User Manual

To insert a memory card, do the following:

(1) Open the battery cover. 

(2) Gently push the card as indicated until the card reaches the bottom of the slot. 

To remove the memory card, gently push it down and it will pop up. Then pull the card 

out of the slot. 

Please charge the battery at least 8 hours prior to its first use.

1.  Connect the cable. 

Connect one end of the supplied AC adapter to the USB port of the 

camcorder and the other end to a wall outlet. 

OR 

Connect one end of the supplied USB cable to the USB port of 

the camcorder and the other end to a powered PC. Make sure the 

camcorder is powered off.

2.  The charging LED turns red and the charge starts.
3.  When the charging is interrupted or the battery pack is fully charged, the charging LED 

will turn green.

 When using a PC to charge the battery, do not power on the camcorder, or 

the charge will stop.

1.  Slide the battery cover open.
2.  Place the included Li-Ion battery into the compartment. Note that 

the metallic contacts must be aligned with the contacts in the 

compartment.

3.  After the battery is properly installed, replace the battery cover.

Open the LCD monitor or press and hold down the Power button for 1 second to turn 

on the camcorder.

To turn off the camcorder, press and hold down the Power button for 1 ~ 3 seconds or 

close the LCD monitor.

 If the camcorder stays inactive for a long period of time, it may automatically 

shut down due to the Auto-Off setting.