Quantum DAT 160 User Guide
Chapter 3 Installing External Tape Drives
Connecting the SCSI Tape Drive
Quantum DAT 160 User’s Guide
28
• If you do not need to change these default settings, proceed to
.
Table 5 External Tape Drive
Default Settings
Default Settings
An external Quantum DAT 160 drive will operate using any voltage in
the range 100–240 volts (0.7 A, 50-60 Hz). No adjustment is needed.
Check the Drive’s SCSI
ID
ID
3
Your Quantum DAT 160 drive is shipped with a default SCSI ID of 3.
Each device on the SCSI bus must have an unique SCSI ID number. The
drive can be assigned any unused ID between 0 and 15. Do not use SCSI
ID 7, which is reserved for the SCSI controller. SCSI ID 0 is typically
assigned to the boot disk and should also not be used unless the tape
drive is on a dedicated SCSI bus.
Parameter
Default Setting
SCSI ID
3
SCSI controller
7
Host operating system
Microsoft 2000, 2003, XP Professional, and
Linux Kernels 2.6 or higher
Note:
The drive can be assigned any unused ID between 0 and 15.
Do not use SCSI ID 7, which is reserved for the SCSI controller.
SCSI ID 0 is typically assigned to the boot disk and should not
be used unless the tape drive is on a dedicated SCSI bus.