Quantum fc1202 User Guide
Chapter 2 FC1202 Bridge Serial/Telnet User Interface
Telnet User Interface (UI) Access
Telnet User Interface (UI) Access
44
Quantum FC1202 User’s Guide
Telnet User Interface (UI) Access
2
To open a Telnet session, the IP address of the FC1202 and a Telnet client
utility are required.
From most Windows 9x, Windows NT, and Windows 2000 systems, a
Telnet session can be started from the Command (DOS) shell using the
following steps:
1
From the Windows Start Menu, open the Command Prompt (DOS)
window.
2
At the command prompt, enter TELNET <IP ADDRESS> where <IP
ADDRESS>
ADDRESS>
is the IP address of the FC1202.
3
Enter the user name and password.
The default user name is root and the default password is password.
The user name and password should be changed from the default
The default user name is root and the default password is password.
The user name and password should be changed from the default
values. The Configuration Menu displays.
Serial User Interface (UI) Access
2
To open a serial session, a terminal emulator utility is required.
From most Windows 9x, Windows NT, and Windows 2000 systems, a
From most Windows 9x, Windows NT, and Windows 2000 systems, a
HyperTerminal session can be started using the following steps:
1
From the Windows
Start
Menu, open
HyperTerminal
.
2
Name the new terminal session.
3
Indicate the appropriate COM port.
4
Configure the serial port settings, as listed in
Note:
After each reboot, a new Telnet session must be started. If the
FC1202 is reset to factory settings, the Ethernet port will have
to be re-configured using the serial interface.