Quantum cp3100 d2d2t User Guide
Initial Setup
Setting the Initial Configuration
46
Setting the CP 3100’s Internal Clock
The CP 3100 has an internal clock that tracks the current date and time. This clock is turned off when
the CP 3100 is shipped. You must set the clock before you use the CP 3100.
the CP 3100 is shipped. You must set the clock before you use the CP 3100.
1.
Click CONFIGURATION. The Date/Time Settings page appears (see Figure 22 on
page 46).
page 46).
Figure 22. Date/Time Settings Page
2.
Enter the information described in the Date/Time Settings page (see Table 3 on page 47).
Click Update. A message confirms that the date and time have been updated.
NOTE: Do not change the date or time when the CP 3100 is reading from or writing to virtual or
physical tape cartridges.
physical tape cartridges.
NOTE: The Date/Time Settings page has a Reset button you can click to cancel your changes.
If you enter the date and/or time using the wrong format, an error message appears showing
the correct format to use. If this happens, click the Back button in your Browser and enter the
appropriate date or time.
If you enter the date and/or time using the wrong format, an error message appears showing
the correct format to use. If this happens, click the Back button in your Browser and enter the
appropriate date or time.