Quantum fc230 User Guide
ATL P-Series Library User’s Guide Addendum - Prism FC230 Router
6331121-03, Ver. 3, Rel. 2
August 2002
FC230 Router Configuration
7
Upgrade the FC230
Firmware
Firmware
0
If a new version of FC230 firmware is available, use the following
procedure to download the new firmware to the FC230 board:
1
Copy the new firmware file to a directory on the service PC.
2
Set the FC230 baud rate and the HyperTerminal baud rate to
115200 using the following steps (this speeds the firmware
download process):
a
At the
Ready
prompt type
set serialportbaudrate 115200,
then press
<Enter>
.
b
Type
saveconfiguration,
then press
<Enter>.
Wait for a new
Ready
prompt.
c
From the HyperTerminal menu (located at the top of the
screen) select
Call/Disconnect.
d
From the HyperTerminal menu select
File/Properties/
Connect To tab/ Configure button.
e
Set the baud rate to
115200
.
f
From the HyperTerminal menu, select
Call/Connect.
3
At the
Ready
prompt:
a
Type
saveconfiguration
and then press
<Enter>
.
b
Type
firmwarerestart
and then press
<Enter>
.
c
Type
zmodem receive
and then press
<Enter>
.
4
From the HyperTerminal menu at the top of the screen select:
Transfer/Send File
5
Browse to the location of the new firmware file:
xxx.IMA
6
In the Send File dialog box, select protocol:
zmodem
7
Click the
Send
button.
The firmware download begins and takes a few minutes to
complete. When the download is complete a new
Ready
prompt
appears on the HyperTerminal screen.
8
At the
Ready
prompt, power cycle the library.
Note:
Press
<Enter>
until you see the ready prompt.
Note:
The library has to be power cycled for the new firmware
to take effect.