Quantum atl 7100 Installation Instruction
Chapter 2 Unpacking and Moving the Library
Packaging the Library for Reshipment
Quantum|ATL 7100 Series Facilities Planning and Installation Guide
21
Packaging the Library for Reshipment
2
If it becomes necessary to crate the library for shipment, use the
procedure below and refer to the figures in this chapter.
procedure below and refer to the figures in this chapter.
1
Open the storage array door.
2
Gently lift the extension axis up and place the vertical axis
block in position (see
block in position (see
, then lower the extension axis to
the bottom position.
3
Install both the top and bottom horizontal axis blocks.
4
Gently slide the robotic mechanism towards the rear of the
library so that is up against the horizontal axis packing blocks.
library so that is up against the horizontal axis packing blocks.
5
Install the tie-wraps securing the extension axis for shipment
(see
(see
.
6
Close the storage array door.
7
Raise the leveling feet by rotating each foot counterclockwise
(as viewed from above) until they are fully retracted.
(as viewed from above) until they are fully retracted.
8
Move the library to the crating area observing all guidelines
described in
described in
9
Slide out the two pallet ramp sections (located underneath the
library) and secure them to the pallet using the Velcro straps
(see
library) and secure them to the pallet using the Velcro straps
(see
10
Unfold the shipping bag and align the white tape to the pallet
bottom with respect to where the library casters will roll onto
the pallet.
bottom with respect to where the library casters will roll onto
the pallet.
Note:
This procedure assumes that all cartridges have been
removed, power is off and cables are disconnected.
removed, power is off and cables are disconnected.
Caution:
Observe proper ESD protective measures to prevent
damage to the library.
damage to the library.