Quantum atl 7100 User Guide
Chapter 2 Operating the Library
Using the Control Panel Menus
Using the Control Panel Menus
30
Quantum|ATL 7100 Series Library Operator’s Guide
8
Exit the menu mode.
Setting a Tape
Drive SCSI
Address
Drive SCSI
Address
2
The SCSI Address/ Drive function is used to set the SCSI address
of tape drives in the library. The library ships with the tape drives
configured as shown in
of tape drives in the library. The library ships with the tape drives
configured as shown in
.
Table 2 Default Tape
Drive SCSI Address
Drive SCSI Address
To change the SCSI addresses of the drives in the library:
1
Enter the menu mode.
Note:
After changing the SCSI address of the library, one of
two things must happen to set the new SCSI ID: the
host controller must issue a “SCSI Bus Reset,” or the
library must be powered off and on again.
two things must happen to set the new SCSI ID: the
host controller must issue a “SCSI Bus Reset,” or the
library must be powered off and on again.
SCSI Address
Drive Number
Physical Location
1
0
top drive
2
1
second drive
3
2
third drive
4
3
fourth drive
5
4
fifth drive
6
5
sixth drive
1 (second bus)
6
bottom drive
Note:
SCSI address 7 is typically reserved for the host
controller.
controller.