Quantum DAT 160 User Guide

6

The DAT Autochanger uses DDS data cassettes. Never use DAT audio grade
cassettes, because the media is not certified for data storage. Also, DAT audio grade
cassettes have a different mechanical specification, which can cause them to jam in
the drive mechanism.

Before inserting the cassette into the magazine check the position of the write-protect
switch. Set all tabs to the enabled position (unless a tape contains data that you don't
want erased). (The write-protect switch enables or disables the ability to write [or
delete] files on the data cassette.)

To write-protect the data cassette, move the write-protect switch away from the edge
of the data cassette. If the write-protect hole is open, the cassette is write-protected
and cannot be written to (or erased).

To write-enable the data cassette, move the write-protect switch toward the edge of
the data cassette, as shown. If the write-protect hole is closed, the cassette is write
enabled and can be written to or erased. Use a ballpoint pen or similar instrument to
move the write-protect switch.

The tape head should be cleaned after every 8 to 10 hours of actual tape motion in
the drive or when the Media Caution signal is displayed. A 20-use cleaning cassette
(adic 39-1028-01) is shipped with your DAT Autochanger. Discard it after 20 uses