Quantum dx100 Installation Instruction
Quantum DX-Series System Unpacking and Installation Instructions
Document 6513502-06 A01
October 2006
Document 6513502-06 A01
October 2006
82
Configuring the DX-Series System
Figure 69 SNMP
Community Management
Community Management
8
Under
New Community
, enter the new community information:
a
A unique name in the
Name
field, the field holds up to 20 characters
(a-z, A-Z), no special characters or blank spaces are allowed
b
IP address in the
IP Address
field, if the value in the Network Mask
edit box ends in a zero, the value in the IP address edit box must also
end in a zero
c
Subnet mask in the
Network Mask
field
d
Access rights for the new community:
•
•
Get
allows SNMP
get
operations:
•
Get/Set
allows both SNMP
get
and
put
operations
9
Click
Add
.
A
Results
page displays indicating the community has been added.
10
Click Send from the SNMP tab to send a test SNMP trap. Verify that the
SNMP trap was received by the specified destination system.
Caution:
If no communities are defined, the DX-Series system is
universally accessible through a “public” community
(read-only).
Note:
A single community with an IP address or network mask set to
0.0.0.0,
or left blank, indicates that IP-address-based access
control is disabled.